Tools
-
-
Make sure you add NO pressure on the fan blades, as it very easily breaks!
-
Fit the fan to the bracket as shown, with label facing towards the bracket and cables on top left.
-
The M3x16 screws will cut their own threads into the plastic - be careful not to over-tighten.
-
-
-
Then fit the hot-end to the fan assembly. Place the fan flat on the table and push the hot-end from the top all the way into the groove.
-
It is important that the hot-end sits all the way inside the groove as otherwise the holes will not align with the effector plate later!
-
Make sure you do not press against the fan blades!
-
Almost done!
Finish Line