You're viewing a previously published revision of this guide. View latest revision

G - Hot-End Fan Assembly

Written By: Dozuki System (and one other contributor)

Difficulty

Easy

Steps

Time Required

Step 1 G - Hot-End Fan Assembly

Make sure you add NO pressure on the fan blades, as it very easily breaks!
Fit the fan to the bracket as shown, with label facing towards the bracket and cables on top left.
The M3x16 screws will cut their own threads into the plastic - be careful not to over-tighten.

Then fit the hot-end to the fan assembly. Place the fan flat on the table and push the hot-end from the top all the way into the groove.
It is important that the hot-end sits all the way inside the groove as otherwise the holes will not align with the effector plate later!
Make sure you do not press against the fan blades!

Member since: 09/24/2009

1 Reputation

11 Guides authored