Skip to main content

Site Navigation

Your Account

Choose Language

You're viewing a previously published version of this guide.  View latest version

Older Newer
  1. Make sure you add NO pressure on the fan blades, as it very easily breaks! Fit the fan to the bracket as shown, with label facing towards the bracket and cables on top left.
    • Make sure you add NO pressure on the fan blades, as it very easily breaks!

    • Fit the fan to the bracket as shown, with label facing towards the bracket and cables on top left.

    • The M3x16 screws will cut their own threads into the plastic - be careful not to over-tighten.

  2. Then fit the hot-end to the fan assembly. Place the fan flat on the table and push the hot-end from the top all the way into the groove.
    • Then fit the hot-end to the fan assembly. Place the fan flat on the table and push the hot-end from the top all the way into the groove.

    • It is important that the hot-end sits all the way inside the groove as otherwise the holes will not align with the effector plate later!

    • Make sure you do not press against the fan blades!

Dozuki System

Member since: 09/24/2009

1 Reputation

11 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 12