Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #6

Edit by HKBay

Edit approved by HKBay


Step Lines

[title] Fit spider to the ball-bearing slides
[* black] Attach the spider to the sliding rails with each two M3x16 on top and two M3x8 screws on bottom.
[* icon_caution] Carriages must face downwards (see picture).
[* icon_caution] Adjust the spider in such a way that the fan points forward towards X and the Z-Probe towards Z tower!
[* black] Fit the PTFE tube into the extractor and tighten the brass connector.
[* icon_caution] Make sure the brass connector goes in at a right angle. Use 10mm Allen Key, but don’t over-tighten!
[* icon_note] Oil the rails with high-quality oil.

Image 1

No previous image


Image 2

No previous image