Changes to Step #7
Step Lines
| [title] Connect End-Stops |
| [* black] Next connect the endstops. The RAMPS board has 6 three-pin headers labeled ENDSTOPS at the top right corner of the board next to the 4-pin I2C header, which is not used. The endstop headers are, from left to right: X-min, X-max, Y-min, Y-max, Z-min and Z-max. |
| [* icon_note] Only the outer (S) and centre pin (-) of each 3-pin header are used with mechanical endstops. As the Kossel has maximum endstops only, the X-min and Y-min endstops are not used. The Z-min position is used for the Z-probe. |
| [* icon_note] The jumpers on the picture are not needed. |
| [* black] Begin with the Z-endstop on row 6 (Z-max), as shown. |
| [* icon_caution] If I2C header is present on your RAMPS, be careful NOT to put it on the 4-pin I2C header by mistake! |
| [* black] Next the Z-Probe on row 5 (Z-min) |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added