Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #6

Edit by Dozuki System

Edit approved by Dozuki System

Before
After
Unchanged

Step Lines

[title] Fit motors to base assembly
[* black] Align motor with plastic bracket, with the cable socket on the left-hand side of the motor viewed from the bracket end (hidden in the picture above). Insert four M3x8 screws and tighten with the ball end of 2.5mm hex key.
[* icon_note] There is a groove in the printed part to reduce the angle of the key slightly. Make sure the screws go in straight - loosen and re-align any screws that have gone in at an angle. Do not tighten fully with the ball-end. Instead use the short leg.
[* black] Repeat for the other 2 brackets. The completed base assembly may now be set aside while you get on with the top assembly.

Image 1

No previous image

Added

Image 2

No previous image

Added