Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Dozuki System

Edit approved by Dozuki System

Before
After
Unchanged

Step Lines

[* black] Fit the micro-switch with the cable leading to the right, using another two M2.5x12 screws.
[* icon_note] The orange switch needs to be aligned with the groove in the probe holder.
[* icon_note] The legs probably need to be bent sideways, as shown in the picture.
[* icon_note] Make sure the micro-switch is held firmly against the holder while being careful not to over-tighten the screws!
[* icon_caution] Double-check that the micro switch is held firmly with no movement whatsoever, as this would negatively affect your printers’ accuracy!

Image 1

No previous image

Added