Changes to Step #1
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
[title] Secure endstop cables |
[* black] Route the endstop cables around the towers and into the channel on the outer or side face of each tower. Make sure you don’t accidentally break the soldering points! Zip-tie in place. |
[* black] Tighten the X, Y and Z endstop cables and zip-tie at the bottom of the towers. |
[* icon_note] Optional: If you want, you can later print these cable holders: http://www.thingiverse.com/thing:655787 |
Image 1
No previous image
Added
Image 2
No previous image
Added