Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #6

Edit by Dozuki System

Edit approved by Dozuki System


Step Lines

[title] RAMPS wiring
[* black] Bring all the loose wires together around the RAMPS board.
[* icon_note] If in any doubt about the wiring, consult the official RAMPS wiring instructions and diagram shown opposite. The diagram is from (click on the wiring diagram at that link to enlarge).
[* icon_note] Note that the diagram is for a conventional printer, not a Delta, so shows 2 Z-motors. It also shows a second extruder and a heated print-bed - just ignore these.
[* black] Connect the hot-end fan to the D9 connector on the RAMPS.
[* icon_caution] Check for the correct polarization; red cable goes into (+), brown cable into (-)!

Image 1

No previous image


Image 2

No previous image