Changes to Step #9
Edit by Dozuki System —
Edit approved by Dozuki System
- Before
- After
- Unchanged
Step Lines
[title] Connect End-Stops (continued) |
[* black] If not already done in the step above, connect the X, Y, Z, and E motors as shown. There are 2 rows of pins for Z- you can use the either one. |
[* icon_caution] Unlike shown on the picture, the green cables from the four motors need to face TOWARDS the green power plug! |
[* black] Connect the hot-end to the + and- pins Marked D10 on the RAMPS board. |
[* icon_note] The hot-end wires are not polarized. |
Image 1
No previous image
Added
Image 2
No previous image
Added