HKBay.com
/
/

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by HKBay —

Edit approved by HKBay

Before
After
Unchanged

Step Lines

[* black] Then align one of the profiles with the two nuts of one of the brackets. Always starting with the outer screw first, loosen the screw 5 full turns, then tighten it 2-3 full turns until the profile is held tightly against the bracket.
[* blackicon_caution] Check that the outer t-slot nut connected properly with the groove in the profile, only then repeat with the inner screw/nut. The inner t-slot nut can be checked visually.
[* black] After both nuts connected properly, add a second profile to the same bracket.
[* blackicon_caution] Check that the outer t-slot nut connected properly with the groove in the profile, only then repeat with the inner screw/nut. The inner t-slot nut can be checked visually.
[* black] After both nuts connected properly, add a second profile to the same bracket.