Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #1

Edit by HKBay

Edit approved by HKBay

Before
After
Unchanged

Step Lines

[title] Fit towers to base
[* icon_caution] It is advisable to put the printer on a solid floor for this step!
[* black] Fit two M3x8 screws and t-slot nuts to each of the 3 motor brackets and tighten them finger-tight. Align the nuts vertically and slide in one of the profiles.
[* icon_note] Use the mullet and adjust the upper nut if necessary. If the profiles don’t fit, try to turn the base over.
[* icon_note] You can also try to adjust the screw slightly using a hex key.
[* black] Once the tower has been pushed down in the bracket and reaches the second nut, invert the frame, align the second nut if necessary, and push the frame profile into flush alignment with the bottom of the motor bracket. Tighten the two screws and repeat for the other 2 towers to complete the build.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added