Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by HKBay

Edit approved by HKBay

Before
After
Unchanged

Step Lines

[title] Fit ball-bearing side rails
[* icon_caution] Attention: Make sure the slides don’t accidentally come off the side rails when pulling them out of their covers! If it happens, it is almost impossible to re-insert the tiny balls into the ball-bearings and we cannot exchange side rails with missing ball bearings!
[* black] Fit 5 t-slot nuts onto the side rails, using five M3x8 screws, leaving 3 holes empty between each screw. Make them finger-tight and align them vertically.
[* black] Then add side rail to tower, bottom of rail sitting firmly against endstop holder. Tighten.
[* icon_note] Check that each t-slot nut is connected firmly inside the profile.
[* icon_reminder] Repeat for the two other corner profiles.

Image 1

No previous image

Added

Image 2

No previous image

Added