Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #4

Edit by HKBay

Edit approved by HKBay

Before
After
Unchanged

Step Lines

[* black] While hex key is in upper position, fit the spring and terminal block from below, compress the spring about 80% (not 100% as shown in the picture!), and tighten the terminal screws.
[* black] Trigger the probe by flicking the short leg past the safety-pin spring into the deployed position.
[* icon_caution] Confirm it is pushed down hard enough by the spring to activate the micro-switch - you should hear the micro-switch click.
[* black] Push from below against the probe leg until the hex key pushes back up past the safety-pin spring. Check that it retracts correctly.
[* icon_note] You may need to bend the safety-pin spring leg to adjust the force required.
[* black] Push from below against the probe leg until the hex key pushes back up past the safety-pin spring.
[* icon_caution] Check that it retracts correctly. You may need to bend the safety-pin spring leg to adjust the force required.
[* black] Repeat several times to confirm that the probe will work reliably. You may need to oil or grease the brass rod during commissioning.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added