Route the endstop cables around the towers and into the channel on the outer or side face of each tower. Make sure you don’t accidentally break the soldering points! Zip-tie in place.
Tighten the X, Y and Z endstop cables and zip-tie at the bottom of the towers.
Optional: If you want, you can later print these cable holders: http://www.thingiverse.com/thing:655787
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.