Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 2 —

Step Type:

Drag to rearrange

Then align one of the profiles with the two nuts of one of the brackets. Always starting with the outer screw first, loosen the screw 5 full turns, then tighten it 2-3 full turns until the profile is held tightly against the bracket.

Check that the outer t-slot nut connected properly with the groove in the profile, only then repeat with the inner screw/nut. The inner t-slot nut can be checked visually.

After both nuts connected properly, add a second profile to the same bracket.

Your contributions are licensed under the open source Creative Commons license.