Then align one of the profiles with the two nuts of one of the brackets. Always starting with the outer screw first, loosen the screw 5 full turns, then tighten it 2-3 full turns until the profile is held tightly against the bracket.
Check that the outer t-slot nut connected properly with the groove in the profile, only then repeat with the inner screw/nut. The inner t-slot nut can be checked visually.
After both nuts connected properly, add a second profile to the same bracket.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.