Align motor with plastic bracket, with the cable socket on the left-hand side of the motor viewed from the bracket end (hidden in the picture above). Insert four M3x8 screws and tighten with the ball end of 2.5mm hex key.
There is a groove in the printed part to reduce the angle of the key slightly. Make sure the screws go in straight - loosen and re-align any screws that have gone in at an angle. Do not tighten fully with the ball-end. Instead use the short leg.
Repeat for the other 2 brackets. The completed base assembly may now be set aside while you get on with the top assembly.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.