Skip to main content

Site Navigation

Your Account

Choose Language

Editing Step 2 —

Step Type:

Drag to rearrange

Fit the M3x25 screw through the one of the brackets and progressively add in this sequence: washer (shiny side towards bearing), first bearing (flange right), second bearing (flange left), belt, second washer (shiny side towards bearing), third washer (shiny side towards nut) and finally the standard nut.

Do not forget to insert one of the closed belts!

You will probably need to hold the nut with needle-nosed pliers as you do up the bolt. Tighten the nut against the bearings but make sure that the bearings can still turn freely!

Repeat for the other 2 brackets. Set aside the top frame while you get on with the next stage.

Your contributions are licensed under the open source Creative Commons license.