Then fit extruder-holder to the back of Z-tower (opposite the LCD cables).
As the t-slot nuts are too close together, they need to be slid into the profile from the top, before attaching the top frame!
Attach the motor to the extruder holder with two M3x16 screws and standard nuts, cables pointing towards the tower.
Mount the extruder at about the same level as the lower endstop holder.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.