Fit the micro-switch with the cable leading to the right, using another two M2.5x12 screws.
The orange switch needs to be aligned with the groove in the probe holder.
The legs probably need to be bent sideways, as shown in the picture.
Make sure the micro-switch is held firmly against the holder while being careful not to over-tighten the screws!
Double-check that the micro switch is held firmly with no movement whatsoever, as this would negatively affect your printers’ accuracy!
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.