Attach the spider to the sliding rails with each two M3x16 on top and two M3x8 screws on bottom.
Carriages must face downwards (see picture).
Adjust the spider in such a way that the fan points forward towards X and the Z-Probe towards Z tower!
Fit the PTFE tube into the extractor and tighten the brass connector.
Make sure the brass connector goes in at a right angle. Use 10mm Allen Key, but don’t over-tighten!
Oil the rails with high-quality oil.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.