It is advisable to put the printer on a solid floor for this step!
Fit two M3x8 screws and t-slot nuts to each of the 3 motor brackets and tighten them finger-tight. Align the nuts vertically and slide in one of the profiles.
Use the mullet and adjust the upper nut if necessary. If the profiles don’t fit, try to turn the base over.
You can also try to adjust the screw slightly using a hex key.
Once the tower has been pushed down in the bracket and reaches the second nut, invert the frame, align the second nut if necessary, and push the frame profile into flush alignment with the bottom of the motor bracket. Tighten the two screws and repeat for the other 2 towers to complete the build.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.