Attention: Make sure the slides don’t accidentally come off the side rails when pulling them out of their covers! If it happens, it is almost impossible to re-insert the tiny balls into the ball-bearings and we cannot exchange side rails with missing ball bearings!
Fit 5 t-slot nuts onto the side rails, using five M3x8 screws, leaving 3 holes empty between each screw. Make them finger-tight and align them vertically.
Then add side rail to tower, bottom of rail sitting firmly against endstop holder. Tighten.
Check that each t-slot nut is connected firmly inside the profile.
Repeat for the two other corner profiles.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.