Skip to main content

Site Navigation

Your Account

Choose Language

Help
Editing Step 2 —

Step Type:

Drag to rearrange

Fit the micro-switch with the cable leading to the right, using another two M2.5x12 screws.

The orange switch needs to be aligned with the groove in the probe holder.

The legs probably need to be bent sideways, as shown in the picture.

Make sure the micro-switch is held firmly against the holder while being careful not to over-tighten the screws!

Double-check that the micro switch is held firmly with no movement whatsoever, as this would negatively affect your printers’ accuracy!

Your contributions are licensed under the open source Creative Commons license.