-
-
Add the fan assembly with J-Head to the effector plate by guiding the PTFE Bowden tubing through the center hole in the effector plate and the 4 cables are routed on the side of the effector plate.
-
Secure the fan assembly with 3 screws on left (looking at the fan); keep the three holes on the left empty.
-
Remove hex key from Z-Probe and add the Z-Probe holder to the remaining holes on left of fan with two screws. The hex key will go through the middle hole, so keep it empty! The right screw needs to be secured with a standard nut.
-
Cancel: I did not complete this guide.
One other person completed this guide.